[Wien] w2web error : sh: x: command not found

[Peter Blaha]

Most likely you started w2web when yout enveronment (WIENROOT, path) was 
not set properly.

Kill the running w2web; make sure your setting are correct in the 
current window (echo $WIENROOT; echo $PATH) and start w2web again.

shaposh at academ.org schrieb:
> Dear Wien2k users,
> whenever i try to run any command using w2web interface,
> i get  "sh: x: command not found" error. 
> All paths are set correctly, and i can run "x" or any other wien2k
> command from the command line without problem.
> Can somebody point me to the solution?
> 
> Best Regards,
> A. Shaposhnikov
> _______________________________________________
> Wien mailing list
> Wien at zeus.theochem.tuwien.ac.at
> http://zeus.theochem.tuwien.ac.at/mailman/listinfo/wien

-- 

                                       P.Blaha
--------------------------------------------------------------------------
Peter BLAHA, Inst.f. Materials Chemistry, TU Vienna, A-1060 Vienna
Phone: +43-1-58801-15671             FAX: +43-1-58801-15698
Email: blaha at theochem.tuwien.ac.at    WWW: 
http://info.tuwien.ac.at/theochem/
--------------------------------------------------------------------------