[Wien] Problem in displaying Energy/ volume curve

[Peter Blaha]

For the E-vol curve you need    gnuplot.

Make sure you have installed it on your Linux.


On 3/28/19 3:23 PM, Mansouri Tahar wrote:
> Hello everyone
> 
> I am a new beginner using wien2k software.
> To make initial training I have started optimizing Al " as an example".
> I have run optimize  volume, c/a-ratio for a cubic structure.
> The calculation arrived at its end but no figure is plotted. I was 
> expecting to see the Energy vs Volume figure but nothing is plotted.
> For your information xcrysden is seems working well as i can see the 
> structure.
> 
> Can please advice.
> Tahar
> 
> _______________________________________________
> Wien mailing list
> Wien at zeus.theochem.tuwien.ac.at
> http://zeus.theochem.tuwien.ac.at/mailman/listinfo/wien
> SEARCH the MAILING-LIST at:  http://www.mail-archive.com/wien@zeus.theochem.tuwien.ac.at/index.html
> 

-- 

                                       P.Blaha
--------------------------------------------------------------------------
Peter BLAHA, Inst.f. Materials Chemistry, TU Vienna, A-1060 Vienna
Phone: +43-1-58801-165300             FAX: +43-1-58801-165982
Email: blaha at theochem.tuwien.ac.at    WIEN2k: http://www.wien2k.at
WWW:   http://www.imc.tuwien.ac.at/TC_Blaha
--------------------------------------------------------------------------