<div dir="ltr"><div>Good day Sir<br><br></div>I have a problem on my wien2k_10. I have successfully installed it on Ubuntu 12.04 LTS. During the compilation there was no error shown. But if run a calculation (e.g x nn and the x sgroup) it shows result and Invalid null command. Also when running the SCF, it shows hup command not found<br>
<br><div><pre>Invalid null command.
specify nn-bondlength factor: (usually=2) [and optionally dlimit (about 1.d-5)]
DSTMAX: 20.0000000000000
ATOM 1 Ti ATOM 2 C
RMT( 1)=2.09000 AND RMT( 2)=1.85000
SUMS TO 3.94000 LT. NN-DIST= 4.08937
ATOM 2 C ATOM 1 Ti
RMT( 2)=1.85000 AND RMT( 1)=2.09000
SUMS TO 3.94000 LT. NN-DIST= 4.08937
NN ENDS
0.0u 0.0s 0:00.00 0.0% 0+0k 0+32io 0pf+0w<br><br></pre><pre>#using the x sgroup<br></pre><pre>Commandline: <b>x sgroup</b><br>
Program input is: <b>""</b>
<br>
<br>
Invalid null command.
0.0u 0.0s 0:00.00 0.0% 0+0k 0+8io 0pf+0w
</pre><pre><br><br></pre>#also in the SCF cycle<br></div><div><pre>hup: Command not found.
Invalid null command.
LAPW0 END
Invalid null command.
LAPW1 END
Invalid null command.
LAPW2 END
Invalid null command.
CORE END
Invalid null command.
MIXER END
ec cc and fc_conv 0 0 1
in cycle 2 ETEST: .1630659300000000 CTEST: .9223692
hup: Command not found.
Invalid null command.
LAPW0 END
Invalid null command.
LAPW1 END
Invalid null command.
LAPW2 END
Invalid null command.
CORE END
Invalid null command.
MIXER END
ec cc and fc_conv 0 1 1
in cycle 3 ETEST: .0815329700000000 CTEST: -.0004331
hup: Command not found.
Invalid null command.
LAPW0 END
Invalid null command.
LAPW1 END
Invalid null command.
LAPW2 END
Invalid null command.
CORE END
Invalid null command.
MIXER END
ec cc and fc_conv 0 1 1
in cycle 4 ETEST: .0815509450000000 CTEST: -.0004820
hup: Command not found.
Invalid null command.
LAPW0 END
Invalid null command.
LAPW1 END
Invalid null command.
LAPW2 END
Invalid null command.
CORE END
Invalid null command.
MIXER END
ec cc and fc_conv 1 1 1
> stop</pre></div><br></div>