<div dir="ltr"><div>Dear WIEN2k users</div><div><br></div><div>In my [runsp_lapw -so -eece] run,</div><div>[x lapw2 -eece] shows a strange work.</div><div><br></div><div>x lapw0 -p</div><div>x lapw1 -up -p</div><div>x lapw1 -dn -p</div><div>x lapwso -up -orb -p</div><div>x lapw2 -up -p -c -so</div><div>x lapw2 -dn -p -c -so</div><div>x lcore -up</div><div>x lcore -dn</div><div>x lapwdm -up -p -so -c</div><div>x lapw2 -c -up -so -p -eece</div><div>x lapw2 -c -dn -so -p -eece</div><div>x lapw0 -p -eece</div><div>x orb -up -p</div><div>x orb -dn -p</div><div>x mixer -eece -orb</div><div><br></div><div>In the first call of lapw2 (without -eece)</div><div>there is no problem.</div><div><br></div><div>However in the second call of lapw2 (with -eece),</div><div>the code warns me for the integration. </div><div>* WARNING: EF not accurate, new emin,emax,NE-min,NE-max</div><div>* not only once, but "every" cycle</div><div><br></div><div>It there anyone who had similar experiences?</div><div><br></div><div><br></div><div><br></div><div>My system is a cubic perovskite (transition-metal oxide)</div><div>with ferromagnetic insulating phase.</div><div><br></div><div>* I tried both of [TETRA] and [TEMP 0.005].</div><div>TETRA shows above problem, but describe well the insulating state.</div><div>TEMP does not show the EF problem, but I could not get the insulating solution with TEMP.</div><div><br></div><div>* Also I tried with a high k-mesh (32x32x32),</div><div>but the problem still appeared.</div><div><br></div><div><br></div><div><br></div><div>Thank you for reading this email.</div><div>Any response in this regard will be very helpful for me.</div><div><br></div><div>With best regards</div><div><br></div><div>- Kyohoon</div></div>