<div dir="ltr">Thank you for your reply, Prof. Blaha. In fact, when I change parameters in inorb, I always do 'rm case.dmat*' and 'rm case.vorb*' , so I think it should not be the problem. But I do value your suggestions, so I started a new session, only used the struct file of Nd4Ni3O8 which is attached here, and then <div>init_lapw -b -rkmax 7.5 -numk 2000 -sp -vxc 5 -lvns 6 </div><div>create inorb and indm by copying them from templates and modify them accordingly </div><div>runsp_lapw -p -orb -i 200 -ec 0.0001 -cc 0.001 -NI</div><div>during the scf cycle, QTL-B warning appeared, but the value was very small (2~3, still could be a trouble?), the density matrix warnings appeared at about the 20th cycle and persisted. </div><div><br></div><div>With regards.</div><div><br></div><div>Fan</div><div><br></div><div><br></div></div>