[Wien] forrtl: severe (174): SIGSEGV, segmentation fault occurred

[Mahmoud Payami]

Dear Laurence,

I did not see any such printouts.
I also used RH10+Ifort8+MKL70, the result was:
Compilation was OK. But in the "x symmetry" step, the system could not
recognize the ifort-file: libcprts.so.5.
However, RH8+ifc7+icc7+mkl61 works without any error.
Do you know any such combinations with new softs that works?

Best regards,
Mahmoud


> One other thing to check; does mixer also printout something like
>  ispin set to           1
>  ispin set to           2
> from a print command at about line 192 also in scfana.f. When I commented
> this print out I ran into problems. You may also want to use -traceback in
> your compile lines options although with a segmentation fault the line
> number can be misleading.
>
> On Wed, 18 Aug 2004, Fred Nastos wrote:
>
> > On August 18, 2004 02:37 pm, Mahmoud Payami wrote:
> > > Dear Fred,
> > >
> > > It is (...8.0.046+patches).
> >
> > O.K.  So in the serial case you find an error in mixer.  Please try the
> > following:
> >
> > 1) Open up SRC_mixer/scfana.f.
> > 2) On line 78 (or thereabouts)  you will see the line
> > FORCE(JATOM)=.false.
> > 3) Comment this line out, and recompile (with -C while debugging).
> > This line is unessecary, and initially JATOM=0, which may cause
> > run-time problems with ifort.
> > 4) Rerun your calculation.
> >
> > Fred
> >
>