[Wien] The number of bands is less than what I want

[Peng Bingrui]

Dear wien2k community

I'm running WIEN2K of 13 version on Linux system.

My case.insp is like this:
-------------------------------------------------------------------------------------------------------------------------------
### Figure configuration
 5.0   3.0                             # paper offset of plot
10.0  15.0                           # xsize,ysize [cm]
 1.0   4                                # major ticks, minor ticks
 1.0   1                                # character height, font switch
 1.1   2    4                          # line width, line switch, color switch
### Data configuration
-14.0  28.0  2                      # energy range, energy switch (1:Ry, 2:eV)
1      0.6847884066            # Fermi switch,  Fermi-level (in Ry units)
1      99                               # number of bands for heavier plotting   1,1
0      1    1.0                        # jatom, jtype, size  of heavier plotting
-------------------------------------------------------------------------------------------------------------------------------

I want to get 99 bands plotted, but there are only 80 bands shown when I open case.bands.agr. And note that although I set the energy range to be (-14.0, 28.0) , the highest band, is below 12.0 eV, which is much lower than 28.0 eV. What should I do to get more bands ?

Thank you very much for your attention.

Sincerely yours,
Bingrui Peng
from the Department of Physics, Nanjing University,
China
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://zeus.theochem.tuwien.ac.at/pipermail/wien/attachments/20170715/c8ff4dca/attachment.html>